Taking Measurements - Using 'Log Manual - Elcometer 319/2 Operating Instructions Manual

5 TAKING MEASUREMENTS - USING 'LOG MANUAL'

Follow this procedure to take measurements manually and log the results into your
gauge memory. Each time a measurement is taken, the readings are written into the
batch selected.
1. From MENU, scroll to Log manual and then press OK.
The LOG MANUAL menu is displayed. This menu lists all the batches.
Empty batches [
manual logging [
cannot be used.
Note: If the gauge memory is full, the batches are unavailable [
batches must be cleared before logging can start.
Batches are given numbers by your gauge (Batch 1, Batch 2, etc.). If required,
TM
use ElcoMaster
of numbers.
10
] and batches which have been used previously for
] can be used for manual logging. Closed batches [
software (see page 17) to give your batches names instead
Measure
Log interval
Setup
]
22/06/07
] and the
12:23
Batch 2
Batch 3
Batch 4
Batch 5
Batch 6
Batch 7
Batch 8
Back