Elcometer 319/2 Operating Instructions Manual page 21

8.2 LIMITS
Limits are the lowest (Lo) and highest (Hi) acceptable values for the measured
parameters. Measurement values outside these limits will trigger the alarm if the
limits are 'on'.
The limits set here are used when measuring without logging (Measure). Limits are
also used when measuring in Log Manual and Log Internal modes, when no limits
have been set and when the limits are set to the 'Limits on' position.
1. Scroll to the parameter you want to set the limits for and press OK.
2. Use the up and down buttons to set the digit of the Lo and Hi limit and then
press OK to move to the next digit.
3. The line with Hi limit:On (or Off) is selected - press OK to change the current
setting (On or Off).
4. Use the down button to go to the line with Lo limit:On or (Off) - press OK to
change the current setting (On or Off).
8.3 LANGUAGE
Use this option to set the display language. Scroll to the required language and then press OK.
Lo Hi
RH 52 75 %
O
Ts -- 33 C
O
Ta -10 -- C
O
Td 0 30 C
O
T 10 29 C
Limits on
Limits off
Back
19