Find Breaks In The Loop Wire - Husqvarna AUTOMOWER 535 AWD Operator's Manual

Symptoms Cause
The product only The product does not have cellular connec-
®
has Bluetooth (short tion to the Automower
range) connection
®
with the Automower
Connect app and not
cellular (long range)
connection.
You cannot connect Only one mobile device can be connected
with the product with to the product with Bluetooth
an additional mobile time.
device.
The cellular connec- There is a problem with the cellular connec-
tion has worked be- tivity.
fore, but does not
work now.

7.6 Find breaks in the loop wire

Breaks in the loop wire are usually the result of
unintentional physical damage to the wire such as when
gardening with a shovel. In countries with ground frost,
also sharp stones that move in the ground can damage
the wire. Breaks can also occur due to the wire being
stretched excessively during installation.
Mowing the grass too low right after the installation can
damage wire insulation. Damage to the insulation may
not cause disruptions until several weeks or months
later. To avoid this, always select the maximum cutting
height the first weeks after installation and then lower
the height one step at a time every second week until
the desired cutting height has been reached.
A defective splicing of the loop wire can also lead to
disruptions several weeks after the splice was done.
A faulty splice can, for example, be the result of the
coupler not being pressed together hard enough with a
pair of pliers, or that a coupler of lower quality than the
original coupler has been used. Please first check all
known splices before further troubleshooting is done.
A wire break can be located by gradually halving the
distance of the loop where the break may have occurred
until there is only a very short section of the wire left.
The following method does not work if
activated. Make sure first that
ECO mode on page 22 .
Refer to
1427 - 009 - 20.12.2022
®
Connect app.
®
at the same
ECO mode is
ECO mode is turned off.
Action
Enter the Automower
mobile device. Select Automower
and do a new pairing operation.
Disable the Automower
all other connected devices. If the problem
stays, set the connected mobile device to
OFF and start it again. If the problem stays,
speak to your dealer.
• Make sure that you have cellular cover-
age in the area.
• Disable Automower
app and enable it again. Wait 1 hour
and try again.
• Restart the product.
• If a new firmware is available in the
app, install it to make sure that you
have the newest firmware.
• Make sure that you have the newest
version of the Automower
app installed.
• If the problem stays, speak to your
dealer.
1. Check that the indicator lamp in the charging
station flashes blue, which indicates a break in
the boundary loop. Refer to
charging station on page 40 .
2. Check that the boundary wire connections to the
charging station are properly connected and not
damaged. Check that the indicator lamp in the
charging station is still flashing blue.
®
Connect app on your
®
Connect
®
Connect app in
®
Connect in the
®
Connect
LED indicator of the
Troubleshooting - 43