Find Breaks In The Loop Wire - Husqvarna AUTOMOWER 305 Operator's Manual

Symptoms Cause
The product is The product has reached its maximum cut-
parked for hours in ting time for the day. Refer to
the charging station. mate of the necessary operating time on
page 23 .
The hatch is closed but the START button is
not pushed.
Parking mode is activated.
The product is not allowed to operate if the
battery temperature is too high or too low.
Uneven mowing re- The product works too few hours per day.
sults.
The shape of the work area requires the use
Lawn coverage function for the product to
of
find its way to all remote areas.
The
to the layout of the work area.
The work area is too large.
Dull blades.
Long grass in relation to the set cutting
height.
Accumulation of grass by the blade disc or
around the motor shaft.
The product detects Terrain wheels are installed, but the Terrain
false collisions and Kit setting is not enabled. Special setting is
moves rearwards and needed to compensate behavior for addition-
turns where the is no al weight.
obstacle.

6.6 Find breaks in the loop wire

Breaks in the loop wire are usually the result of
unintentional physical damage to the wire such as when
gardening with a shovel. In countries with ground frost,
also sharp stones that move in the ground can damage
the wire. Breaks can also occur due to the wire being
stretched excessively during installation.
Mowing the grass too low right after the installation can
damage wire insulation. Damage to the insulation may
not cause disruptions until several weeks or months
later. To avoid this, always select the maximum cutting
height the first weeks after installation and then lower
the height one step at a time every second week until
the desired cutting height has been reached.
1462 - 005 - 24.03.2021
Make an esti-
How often? setting is incorrect in relation
Action
No action.
Push the STOP button to open the hatch.
Enter the PIN code and confirm with the OK
button. Push the START button and then
close the hatch.
Change the operating mode. Refer to
ating modes - Park on page 33 .
Check that the charging station is placed in
an area with protection from the sun.
Increase the mowing time. Refer to
on page 23 .
Steer the product to a remote area. Refer to
Lawn Coverage and Systematic Passage
Mowing on page 25 .
Check that the correct
selected.
Try limiting the work area or extending the
schedule. Refer to
Replace all the blades. Refer to
blades on page 36 .
Increase the cutting height and then succes-
sively lower it.
Check that the blade disc rotates freely and
easily. If not, screw off the blade disc and re-
move grass and foreign objects. Refer to
clean the chassis and blade disc on page 35 .
Enable Terrain Kit setting. Refer to
on page 31 .
A defective splicing of the loop wire can also lead to
disruptions several weeks after the splice was done. A
faulty splice can, for example, be the result of the
coupler not being pressed together hard enough with a
pair of pliers, or that a coupler of lower quality than the
original coupler has been used. Please first check all
known splices before further troubleshooting is done.
A wire break can be located by gradually halving the
distance of the loop where the break may have occurred
until there is only a very short section of the wire left.
The following method does not work if
activated. Make sure first that
off. Refer to ECO mode on page 29 .
Oper-
Schedule
How often? value is
Schedule on page 23 .
Replace the
To
Terrain kit
ECO mode is
ECO mode is switched
Troubleshooting - 45