Find Breaks In The Loop Wire - Husqvarna AUTOMOWER 435X AWD Operator's Manual

Symptoms Cause
Uneven mowing The product works too few hours per
results. day.
The
relation to the layout of the work area.
The shape of the work area requires
the use of
find its way to all remote areas.
The work area is too large.
Blunt blades.
Long grass in relation to the set cutting
height.
Accumulation of grass by the blade
disc or around the motor shaft.

6.7 Find breaks in the loop wire

Breaks in the loop wire are usually the result of
unintentional physical damage to the wire such
as when gardening with a shovel. In countries
with ground frost, also sharp stones that move in
the ground can damage the wire. Breaks can
also occur due to the wire being stretched
excessively during installation.
Mowing the grass too low right after the
installation can damage wire insulation. Damage
to the insulation may not cause disruptions until
several weeks or months later. To avoid this,
always select the maximum cutting height the
first weeks after installation and then lower the
height one step at a time every second week until
the desired cutting height has been reached.
A defective splicing of the loop wire can also lead
to disruptions several weeks after the splice was
done. A faulty splice can, for example, be the
result of the original coupler not being pressed
together hard enough with a pair of pliers, or that
a coupler of lower quality than the original
coupler has been used. Please first check all
known splices before further troubleshooting is
done.
A wire break can be located by gradually halving
the distance of the loop where the break may
1035 - 001 - 04.02.2019
How often? setting is incorrect in
Area 1-5 for the product to
Action
Increase the mowing time. Refer to
Timer on page 26 .
Check that the correct
ue is selected.
Area 1-5 to steer the product to a
Use
remote area. Refer to
on page 27 .
Try to limit the work area or extend the
work time. Refer to
Replace all the blades. Refer to
place the blades on page 33 .
Increase the cutting height and then
successively lower it.
Check that the blade disc rotates freely
and easily. If not, screw off the blade
disc and remove grass and foreign ob-
Clean the product on
jects. Refer to
page 32 .
have occurred until there is only a very short
section of the wire left.
The following method does not work if
mode is activated. Make sure first that ECO
mode is turned off. Refer to ECO mode on page
27 .
1. Check that the indicator lamp in the charging
station flashes blue, which indicates a break
in the boundary loop. Refer to
in the charging station on page 45 .
2. Check that the boundary wire connections to
the charging station are properly connected
and not damaged. Check that the indicator
lamp in the charging station is still flashing
blue.
How often? val-
Lawn coverage
Timer on page 26 .
Re-
ECO
Indicator lamp
Troubleshooting - 47