Certificate Of Compliance - Headwall NANO-HYPERSPEC Installation And Operation Manual

®
HYPERSPEC III INSTALLATION
(5) When the WinPcap installation completes the remaining open window is the Hyperspec
Wait for the progress to proceed. The Hyperspec
Finish.
(6) A window prompt opens, indicating the changes are incomplete until the computer is restarted, and asking to
restart the computer now or later. Make the choice as necessary. The installation of the Hyperspec
is complete and ready to operate after the computer restart.
Navigate to the folder C:\headwall and verify the presence of the dem and radioCal
folders, if these were ordered for the system. If they are not present, copy and paste
the folders from the installation directory into the headwall directory.
(7) Restart the computer.
Once the computer restarts, the configuration and installation will complete and Hyperspec
configuration.

2.3.5 Certificate of Compliance.

The document package shipped with each device contains a Certificate of Compliance (C of C). For devices other than the
®
Nano Hyperspec , this C of C data is used in the configuration steps. Locate the document in the supplied folder, found
under the foam lid liner. The data in the following fields is found in the top section of the C of C. The C of C is useful for
both configuring the system as well as working with Headwall Support, if needed.
• Serial Number
• Model Number
• Registration Pixel
• Average Dispersion
• Nominal Pixel_pitch
• Average Pixel_Disp
• Spectral Rows
• Pixel() Wave
2-28
®
Figure 2-35. Hyperspec® III Installation Complete.
NOTE
III wizard completes, showing the following window. Click,
®
III progress window.
®
III software
®
III will be ready for