Adding Devices To The System; Connecting Power,Setting Country, Language And Date/Time - Danfoss Link CC Installation Manual

Installation Guide

4 . 1 . Adding devices to the system

When adding devices to the Danfoss Link™ system, the distance between the
Danfoss Link™ CC and the device must not exceed 1.5m. To accomplish this
Danfoss Link™ Battery Supply Unit (BSU) is offered as an installation tool.
1. Slide off the lid and add batteries.
2. Slide the lid back on and attach the Danfoss Link™ BSU
battery pack onto the back of the Danfoss Link™ CC. When
ready to do the commissioning, turn the switch located on
the Danfoss Link™ BSU to the ON position.
Danfoss Link™ CC will now start up. This takes approximately
30 seconds.
A battery pack (BSU) can be ordered on Danfoss code no. 014G0262.
4 .2 . Connecting power, setting country, language and date/time
Select Language
1
Scroll down to select
16 12/2014
Danfoss Link™ CC
Select Country
2
Scroll down to select
?
VISGL90N
Set Date and Time
3
Set Date and Time
?
Danfoss Heating Solutions
+
x 10
-
1.5 V
AA
1 0
BSU
?