General Information; Safety Instructions - SPX FLOW APV DELTA RGMS4 Instruction Manual

APV
APV_RGMS4_UK-1_112018.qxp
Modulating valve with product diaphragm
DELTA RGMS4 - MFS + MFH 3A
Instruction manual: rev. 1
1.

General Information

This instruction manual should be read carefully by the competent
operating and maintenance personnel.
We point out that we will not accept any liability for damage or
malfunctions resulting from the non-compliance with this
operating manual.
Descriptions and data given herein are subject to
technical changes.
2.

Safety Instructions

DANGER!
- The technical safety symbol draws your attention to important
!
directions of operating safety. You will find it wherever the activities
described are bearing risks of personal injury.
- Depressurize and, if possible, discharge the line and cleaning
system before any maintenance work.
!
- Do not touch the yoke area or actuating area (positioner) when the
valve is installed. Risk of injury through sudden valve operation.
- Electric and pneumatic lines must be disconnected before
assembly or disassembly of the valve (e.g. for seal replacement).
!
- Do not reach into the valve body when the valve is dismantled.
Observe instructions given for valve in installed state.
- In case of damage of the diaphragm, fluids will leak from the
leakage bore in the yoke area.
- Attention: Risk of burn
To prevent personal injury, the valves must not be touched during
!
CIP cleaning or sterilization with hot water or steam.
- Observe Service Instructions to ensure safe maintenance of the
valve. The valve must only be assembled, disassembled and
reassembled by persons who have been trained in APV valves or
by SPX FLOW service team members. If necessary, contact your
local SPX FLOW representative.
UK
2