Fixing The Weighing; Protection Device; Precautions - Jadever SKY User Manual

1. When installing the
weighing pan, tighten the
fixing screw in the centre of
the plastic weighing pan.
1. In the upright position, locate the shipping protection screw device on the left side of the
scale.
2. Before using the scale, unscrew counterclockwise and remove the shipping protection
screw.
3. Before transporting the scale, hold the shipping protection screw down inwards and tighten
it clockwise.
1. Please pay attention to the environment when performing weight calibration on the
scale. Avoid wind blow and vibration.
2. Use of wrong batteries or wrong wiring may cause danger.
3. 10 minutes warm up till the RED light off before activating the scale.
Electronic Scale
Weighing Pan Fixing Steps
2. Unscrew and remove the
shipping protection screw on
the side of the scale.
Protection Device Disassembly Steps

Precautions

3. After removing the shipping
protection screw on the side of
the scale, fasten the shipping
protection buckle.
1