Inviting Another Party Into An Active Conference Call; Holding/Resuming A Conference Call; Ending A Conference Call; Multicast Paging - Yealink W60P User Manual

Yealink W53P & W60P User Guide
The conference call is placed on hold.
6. Enter the number of the new party, and then press the OK key or Send.
7. When the new party answers the call, press Conf. to add the new party to the conference.
8. Repeat steps 5 to 7 until you add all parties.
Note
The procedures for setting up a network conference call on specific servers may be different. Contact your system admin-
istrator for more information.

Inviting another Party into an Active Conference Call

Any party in the conference call can invite other party into an active conference call.
Procedure
1. Press New Call.
2. Enter the desired number and dial out.
3. When the new party answers the call, press Options, and then select Conference.
The new party is joined to the conference call.

Holding/Resuming a Conference Call

Procedure
1. Any party in the conference call press Options, and then select Hold.
The party will only place himself/herself on hold. Other parties can continue the conference call normally. The con-
ference call will only be held when all parties in the conference call place themselves on hold.

Ending a Conference Call

Procedure
1. The conference initiator presses the On-hook key or End.
If any party in the conference ends the call, the other parties remain connected.

Multicast Paging

Multicast Paging allows you to easily and quickly broadcast instant audio announcements to users who are listening to
a specific multicast group on a specific channel.
The IP phone supports the following 31 channels:
0: Broadcasts are sent to channel 0.
l
1 to 25: Broadcasts are sent to channel 1 to 25. We recommend that you specify these channels when broadcasting
l
with Polycom IP phones which have 25 channels you can listen to.
26 to 30: Broadcasts are sent to channel 26 to 30. We recommend that you specify these channels when broad-
l
casting with Yealink IP phones
Note that all IP phones in the multicast paging group must be deployed in the same network, since a broadcast is used.
The IP phone can only send/receive broadcasts to/from the listened channels. Other channels' broadcasts will be
ignored automatically by the IP phone.
Topics
Sending Multicast Paging
Receiving Multicast Paging
58