Safety Precautions - Avoid Injury - Read This First - TE Connectivity CAPI-6T Operation Manual

SAFETY PRECAUTIONS — AVOID INJURY — READ THIS FIRST!
Safeguards are designed into this application equipment to protect operators and maintenance personnel from
most hazards during equipment operation. However, certain safety precautions must be taken by the operator
and repair personnel to avoid personal injury, as well as damage to the equipment. For best results, application
equipment must be operated in a dry, dust-free environment. Do not operate equipment in a gaseous or
hazardous environment.
Carefully observe the following safety precautions before and during operation of the equipment:
Always wear approved eye protection while operating
equipment.
Moving parts can crush and cut. Always keep guard(s)
in place during normal operation.
Electrical shock hazard.
Observe main electric on/off switch.
Always turn off the main power switch and disconnect
the electrical cord from the power source when
performing repair or maintenance on the equipment.
Ensure that guards are in place and secure to
equipment.
Do not operate the equipment without guards in place.
In case of partial or general machine malfunction, ALWAYS perform the following steps:


Actuate an Emergency-Stop button.

Actuate the System Shutdown function, if possible.

Actuate the machine Disconnect Switch.

Use lock-out / tag-out device on the machine Disconnect Switch.

Unplug / switch off machine Power from power source.

Seek immediate medical attention, if required.
Contact TE Connectivity Support Center
Rev A
Always disconnect air supply and then exhaust system
air pressure before performing maintenance or repair
on the equipment.
Always disconnect the air and lockout the tool when not
in use or when head or tool holder is detached.
Use caution when working with this equipment.
Never insert hands into installed equipment.
Never wear loose clothing or jewelry that may catch in
moving parts of the equipment.
Never alter, modify, or misuse the equipment.
Never stare at the bright light used for machine lighting.
Bright light can damage the eye.
Never use the machine for other than what it is
designed, which is pressing connectors onto circuit
boards. Do not use the machine for crushing any items.
409-32048
3 of 64