Revisions; Revision History; Introduction; About These Operating Instructions - TE Connectivity HT11K Operating Instructions Manual

HT11K Hand Tool NANOMQS 0.13-0.35 SQ.MM
1

Revisions

1.1

Revision history

Rev.
A
2

Introduction

2.1

About these operating instructions

These operating instructions describe the use and operation of the HT11K hand tool and
the necessary maintenance measures.
All persons using the hand tool must therefore be familiar with these operating instruc-
tions and follow them.
These operating instructions must be available with the hand tool at all times.
The owner and/or user is obliged to supplement these operating instructions with instruc-
tions in line with existing national regulations for accident prevention and environmental
protection.
These operating instructions apply to the following hand tool from TE Connectivity:
HT11K Hand Tool NANOMQS TAB 0.13-0.35
Warranty claims, liability
TE Connectivity disclaims all liability for any loss or damage arising from failure to ob-
serve instructions on the hand tool or in the operating instructions.
The manufacturer is not liable for any loss or damage arising from unauthorised changes
or modifications to the hand tool.
Service
For further information and technical support, please contact the TE Connectivity Cus-
tomer Support Centre. For addresses, see Section 9.
2.2

Signs and symbols used in this document

The signs and symbols mentioned in this section are used in these operating instructions.
OPERATING INSTRUCTIONS
411-18608-1_Rev.A
Date Description
19.09.2016 First version
Table 1: Revision history
Page 2 - 9
Name
L. Sandhu
TE P/N 4-1579014-2