Arranty - Kontron DIMM-PC/MD Product Manual

DIMM-PC/MD Product Manual
The reproduction, transmission or use of this document or its contents is not permitted
without expressed written authority. Violators will be liable for damages. All rights,
including rights created by patent grant or registration of a utility model or design, are
reserved.
1.4 Warranty
Each board is carefully and thoroughly tested before being shipped. If, however,
problems should occur during the operation, please check your user specific settings of
all boards included in your system. That is often the source of the error. If a board is
defect, it can be sent to your supplier for repair. Please take care of the following steps:
1. The board returned should correspond to the factory default settings since a test is
only possible under these settings.
2. Upon receipt of the board, please be aware that your user specific settings were
changed during the test.
Within the guarantee, the repair is free as long as the guarantee conditions were held. If
no error has been found, you will be charged with the test costs due to the high test
expenditure. Repairs outside of duration of the guarantee will be charged.
This Kontron product is warranted against defects in material and workmanship for our
guaranteed warranty period from the date of shipment. During the warranty period,
Kontron will, at its option, either repair or replace products which prove to be defect.
For warranty service or repair, the product must be returned to a service facility
designated by Kontron.
The foregoing warranty shall not apply to defects resulting from improper or inadequate
maintenance or handling by buyer, unauthorized modification or misuse, operation
outside of the environmental specifications for the product, or improper installation or
maintenance.
Kontron will not be responsible for any defects or damages due to a faulty Kontron
product other than the products supplied by Kontron
Kontron® Embedded Modules GmbH 2
User Information
Revision 1.0