Grounding The Robot Unit; Installing The Robot Controller; Cautions For Designing The Robot Hand - Denso VP-G SERIES Installation & Maintenance Manual

1.2.3

Grounding the Robot Unit

Ground the grounding terminal of the robot unit with a wire of 5.5 mm
NOTE: Use a dedicated grounding wire and grounding electrode. Do not share them
with any other electric power or power equipment such as a welder.
1.3

Installing the Robot Controller

For the installing procedures of the robot controller, refer to the RC7M CONTROLLER
MANUAL, Section 6.2 "Installing the Robot Controller."
1.4

Cautions for Designing the Robot Hand

Refer to the GENERAL INFORMATION ABOUT ROBOT for VP-G SERIES, Chapter 3,
Section 3.5 "Precautions When Designing the End-effectors."
Grounding the Robot Unit (VP-G series)
6
2
or more.