Table of Contents
Advertisement
Safety Instructions
General safety instructions
For qualified staff only
This manual is intended exclusively for acknowledged and qualified electricians who are totally
conversant with the safety standards of electrical drive and automation technology. Project
management, installation, setup, maintenance and testing of the equipment must be carried out
by an acknowledged and qualified electrician who is totally conversant with the safety standards
of electrical drive and automation technology.
Proper use of equipment
MELSERVO-Series equipment is only designed for use in the areas described in this manual.
Be sure to comply with all the characteristics stated in this manual. Only additional or
supplementary devices recommended by MITSUBISHI ELECTRIC EUROPE may be used.
Any other use or application of the products is deemed to be improper.
Relevant safety regulations
All safety and accident prevention regulations relevant to your specific application must be
observed in the system design, installation, setup, maintenance, servicing and testing of these
products.
The regulations listed below are particularly important. This list does not claim to be complete;
however, you are responsible for knowing and applying the regulations applicable to you.
VDE/EN Standards
– VDE 0100
(Regulations for electrical installations with rated voltages up to 1,000V)
– VDE 0105
(Operation of electrical installations)
– VDE 0113
(Electrical systems with electronic equipment)
– VDE 0160
(Configuration of electrical systems and electrical equipment)
Fire prevention regulations
Accident prevention regulations
– VBG No. 4 (electrical systems and equipment)
Low-voltage regulation
MELSERVO J2-Super
I
Advertisement
Table of Contents
