Mitsubishi Electric MELSERVO MRJ2S-B Instruction Manual page 32

Introduction
Fig. 1-18: Servo amplifier MR-J2S-350B or less
No. Name
Bus cable connector (CN1A)
Bus cable connector (CN1B)
Communication connector
(CN3)
Name plate
Encoder connector (CN2)
Charge lamp
Main circuit terminal block
(TE1)
Control circuit terminal block
(TE2)
Protective earth terminal (PE) Module grounding
Fan
Tab. 1-2: Operating elements and their meaning
b
CAUTION:
Any mixing up of the connectors CN1A, CN1B, CN3 and CN2 can lead to a shortcircuit
and damage to the inputs and outputs.
1 - 14
MR-J2S-100B or less
Description
Used to connect the servo system controller or
preceding axis servo amplifier.
Used to connect the subsequent axis servo
amplifier or termination connector (MR-A-TM)
Used to connect a personal computer or output
analog monitor data.
—
Used for connection of the servo motor
encoder.
Lit to indicate that the main circuit is charged.
While this lamp is lit, do not reconnect the
cables.
Used to connect the input power supply and
servo motor.
Used to connect the control circuit power
supply and regenerative brake option.
—
Operating elements
MR-J2S-200B and MR-J2S-350B
Reference
Section 3.1.3
Section 3.1.3
Section 3.1.3
Section 1.3.3
Section 3.1.3
—
Section 3.1.2
Section 3.1.2
Section 3.4
—
S000512C