Load Handling - Xtreme XRM1145 Operation And Safety Manual

9. Lower the attachment to the ground in a level
position.
Figure 7-36. Lower Attachment To Ground In Level
Position.
10. Tilt and lower boom until pivot pins (A) have dis-
connected from attachment hooks (8).
Figure 7-37. Tilt And Lower Boom To Release Pivot Pins (A)
From Attachment Hooks (B).
11. Retract the boom to fUlly disconnect the attach-
ment from the quick attach link.
Xtreme Manufacturing
61
Operation
Load Handling
ADANGER
~ Injury or death by electrocution can
result from contact with or inade-
- - quate clearance with energized
power lines or apparatus.
• NEVER operate the vehicle in an area where
active overhead power lines, overhead or
underground cables, or other power sources
exist.
• Contact the appropriate power or utility com-
pany to de-energize power lines or take other
suitable precautions.
Keep the vehicle, attachments, and
~
loads a. safe distance from electrical
~
power Imes.
• Remain at least 10 feet (3 meters), piUS an
additional 0.4 inches (10 millimeters) for each
1,000 Volts over 50,000 Volts, from active
power lines and other power sources.
• Worksite operating directives and/or local or
state codes might require a greater distance.
• Know the maximum height and reach of this
reach forklift.
Failure to follow proper safety
A
procedures when lifting, lowering,
and traveling with a load can cause
property damage, injury, or death.
DO NOT exceed vehicle capacity of 11,000 pounds
(4989.5 Kilograms). The total rated capacity of the
forks being used must equal or exceed vehicle
capacity. Forks can break causing loss of load and
possible injUry or death.
DO NOT exceed the manufacturer's
~
rated load for any auxiliary attach-
ment. Any attempt to lift or carry
~
loads in excess of the manufacturer's
rated load may cause vehicle tip over,
loss of load, or structural damage which could
result in injUry or death.
800-497-1704