Operation
Attachment Removal
NOTE: To remove a standard carriage with forks,
spread the forks apart on the carriage shaft. This
provides adequate support for the carriage to stand
alone.
1. Bring the vehicle to a complete stop.
2. Move the travel select lever to NEUTRAL (N).
3. Set the parking brake switch to ON (engaged).
4. Extend the boom approximately 18 to 20 inches
(0.46 to 0.5 meters).
5. Tilt the attachment backward.
6. Disconnect the quick attach couplers (this only
applies to attachments with a quick attach
hydraulic system).
Figure 7-33. Disconnect Quick Attach Couplers.
(A) Female Coupler. (8) Male Coupler.
Xtreme Manufacturing
60
7. Raise the quick attach lock lever.
--="'~
Figure 7-34. Raise Quick Attach Lock Lever.
B. Pull out the quick attach pin at the bottom of the
quick attach link.
Figure 7-35. Pull Quick Attach Pin From Attachment And
Quick Attach Link.
800-497-1704