Load Handling - Xtreme xr1255 Operation And Safety Manual

1. Tilt and lower boom until pivot pins (A) have disconnect-
ed from attachment hooks (B).
Figure 81. Tilt and Lower Boom to Release Pivot Pins (A) from Attachment
Hooks (B).
11. Retract the boom to fully disconnect the attachment from
the quick attach link.

Load Handling

Death or serious injury by electrocution
will result from contact with or inadequate
clearance with energized power lines or
apparatus.
• Never operate the forklift in an area where active
overhead power lines, overhead or underground
cables, or other power sources exist.
• Contact the appropriate power or utility company to de-
energize power lines or take other suitable precautions.
DO NOT
components without the use of appropriate
lifting equipment.
Operation Manual
B
A
Danger
Warning
try to lift or handle heavy
Keep the forklift, attachments, and loads a
safe distance from electrical power lines.
• Remain at least 10 feet, plus an additional 0.4 inches)
for each 1,000 Volts over 50,000 Volts, from active pow-
er lines and other power sources.
• Work site operating directives and/or local or state
codes might require a greater distance.
• Know the maximum height and reach of this forklift.
Failure to follow proper safety procedures
when lifting, lowering, and traveling with
a load could cause death, serious injury, or
property damage.
DO NOT exceed forklift capacity of 12,000 lbs. The total
rated capacity of the forks being used must equal or exceed
forklift capacity. Forks can break causing loss of load and
could result in death or serious injury.
DO NOT exceed the manufacturer's rated
load for any auxiliary attachment.
attempt to lift or carry loads in excess of the
manufacturer's rated load may cause forklift
tip over, loss of load, or structural damage
which could result in death, serious injury, or property
damage.
Failure to keep personnel clear of the load
area while the load is being raised or lowered
could result in death or serious injury. DO
NOT lift, swing, or move a load over anyone
or over a forklift cab.
• Review the rated load capacity of each auxiliary
attachment before performing any operation.
• Use the correct load chart and NEVER exceed specified
weights and load centers.
• DO NOT exceed the manufacturer's recommended load
capacity.
• DO NOT operate the forklift with an unsafe load
distribution.
64
Operation
Warning
Warning
Any