Mercedes-Benz S-Class 2019 Operator's Manual page 58

56
Occupant safety
additional connection between the child
restraint system attached with LATCH-
type (ISOFIX) and the vehicle.
If necessary, move head restraint
#
upwards ( page 107).
→
Fold up cover 2 of Top Tether anchorage
#
3.
Install the LATCH-type (ISOFIX) child restraint
#
system with Top Tether. Always comply with
the child restraint system manufacturer's
installation instructions when doing so.
Guide Top Tether belt
#
restraint 1
bars.
Hook Top Tether hook
#
4 without twisting into Top Tether anchor‐
1
age 3.
Tension Top Tether belt 4. Always comply
#
with the child restraint system manufactur‐
er's installation instructions when doing so.
4 under head
between the two head restraint
5 of Top Tether belt
Fold down cover 2 of Top Tether anchorage
#
3.
If necessary, slide head restraint
#
wards ( page 107). Make sure that you do
→
not interfere with the correct routing of Top
Tether belt 4.
Securing the child restraint system with the
seat belt
Securing the child restraint system with the
seat belt on the rear seat
When installing a belt-secured child restraint
system, observe the following:
O Always comply with the manufacturer's
installation and operating instructions for
the child restraint system used.
O When using a category 0/0+ baby car
seat and a category I rearward-facing
child restraint system on a rear seat:
adjust the front seat so that the seat does
not touch the child restraint system.
O When using a category I forward-facing
child restraint system: remove the head
1 down‐