Mercedes-Benz S-Class 2019 Operator's Manual page 461

Align center cap 2 on the rear passenger
#
compartment side of center cover
hub cap on one lug hole 1.
Position the hub cap and turn the center
#
cover clockwise until the hub cap engages
physically and audibly.
Aluminum hub cap
To remove: position socket
#
1.
% The socket can be found in the tire-change
tool kit.
Position wheel wrench
3 of the
#
Using wheel wrench 3, turn hub cap
#
counter-clockwise and remove it.
To install: position hub cap
#
it is completely flush with the wheel.
Position socket
#
2 on hub cap
3 on socket 2.
1
1 and turn until
2 on hub cap 1.
Wheels and tires 459
Attach wheel wrench 3 to socket
#
tighten the hub cap clockwise.
Specified tightening torque: 18 lb-ft
(25 Nm).
Raising the vehicle when changing a wheel
Requirements:
There are no persons in the vehicle.
R
The vehicle is prepared for a wheel change
R
( page 458).
→
The hub caps have been removed
R
( page 458).
→
Important notes on using the jack:
Use only the vehicle-specific jack that has
R
been tested and approved by Mercedes-Benz
to raise the vehicle.
The jack is only designed for raising and
R
holding the vehicle for a short time while a
wheel is being changed and not for mainte‐
nance work under the vehicle.
2 and