Mercedes-Benz S-Class 2019 Operator's Manual page 443

ing condition ( page 437). Observe the
→
notes on tire temperature (
% The values displayed in the multifunction dis‐
play may deviate from those of the tire pres‐
sure gauge as they refer to sea level. At high
altitudes, the tire pressure value indicated by
a pressure gauge are higher than those
shown by the on-board computer. In this
case, do not reduce the tire pressure.
Make sure to observe the following further rela‐
ted subject:
Notes on tire pressure (
→
R
Restarting the tire pressure monitoring sys‐
tem
Requirements:
The recommended tire pressure is correctly
R
set for the respective operating condition on
each of the four wheels (
→
Restart the tire pressure monitoring system in
the following situations:
The tire pressure has changed.
R
The wheels or tires have been changed or
R
page 435). newly installed.
→
On-board computer:
Service
,
Swipe downwards on Touch Control on the
#
left-hand side of the steering wheel.
The Use Current Pressures as New Refer-
ence Values?
function display.
Press a to confirm the restart.
#
The Run Flat Indicator Restarted
page 435)
shown in the multifunction display.
Current warning messages are deleted and
the h yellow warning lamp goes out.
After you have driven for a few minutes, the
system checks whether the current tire pres‐
sures are within the specified range. The cur‐
page 435).
rent tire pressures are then accepted as ref‐
erence values and monitored.
Make sure to observe the following further rela‐
ted subject:
Notes on tire pressure (
R
Tires
.
message is shown in the multi‐
message is
page 435)
→
Wheels and tires 441
Radio equipment approval of the tire pres‐
sure monitoring system
Radio equipment approval numbers
Country Radio type approval number
Canada IC: 2546A-GG4T
IC: 2546A-DG6W2D4
IC: 2546A-MC34MA4
Le présent appareil est conforme
aux CNR d'Industrie Canada
applicables aux appareils radio
exempts de licence. L'exploita‐
tion est autorisée aux deux con‐
ditions suivantes:
(1) l'appareil ne doit pas produire
de brouillage, et
(2) l'utilisateur de l'appareil doit
accepter tout brouillage radioé‐
lectrique subi, même si le
brouillage est susceptible d'en
compromettre le fonctionnement.