Mercedes-Benz S-Class 2019 Operator's Manual page 465

Press the wheel firmly against the
#
wheel hub when screwing on the first
wheel bolt.
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated until they are
finger-tight.
Unscrew the alignment bolt.
#
Tighten the last wheel bolt until it is finger-
#
tight.
Lower the vehicle ( page 463).
→
#
Lowering the vehicle after a wheel change
Requirements:
The new wheel has been installed
R
( page 462).
→
Place the ratchet onto the hexagon nut of the
#
jack so that the letters "AB" are visible.
To lower the vehicle: turn the ratchet of the
#
jack counter-clockwise.
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated
Specified tightening torque: 111 lb-ft
(150 Nm).
& WARNING Risk of injury through incor‐
rect tightening torque
The wheels could come loose if the wheel
bolts or wheel nuts are not tightened to the
prescribed tightening torque.
Make sure the wheel bolts or wheel
#
nuts are tightened to the prescribed
tightening torque.
If you are not sure, do not move the
#
vehicle. Consult a qualified specialist
workshop and have the tightening tor‐
que checked immediately.
Check the tire pressure of the newly moun‐
#
ted wheel and adjust accordingly.
Vehicles with a tire pressure monitoring
#
system: Restart the tire pressure monitoring
system (
Make sure to observe the following further rela‐
(1 to 5).
ted subject:
Notes on tire pressure (
R
Wheels and tires 463
page 441).
→
page 435)
→