Table of Contents
Advertisement
PM SERIES
Feedback protection
45
Ext. Fire Alarm
46
Ext. Smoke Alarm
47
battery damaged
48
battery over-temperature
49
model set wrong
50
4.5 Options
SNMP Card
CAUTION!
For network management configuration and use, refer to the separate user
manual - Network Management Card with Environmental Monitor - shipped with
the CARD.
Network Management Card replacement (internal SNMP)
• Loosen the 2 torque screws (on each side of the card).
• Carefully pull out the card. Reverse the procedure for re-installation
The slot called SNMP supports the MEGAtec protocol. We advise that NetAgent II-3 port is also a
tool to remotely monitor and manage any UPS system
NetAgent II-3Ports supports the Modem Dial-in (PPP) function to enable the remote control via
the internet when the network is unavailable.
In addition to the features of a standard NetAgent Mini, NetAgent II has the option to add
NetFeeler Lite to detect temperature, humidity, smoke and security sensors. Thus, making
NetAgent II a versatile management tool. NetAgent II also supports multiple languages and is
setup for web-based auto language detection.
Relay card
The card is used for providing the interface for UPS peripheral monitoring. The contact signals
can reflect UPS running status. The card is connected to peripheral monitoring devices via DB9
female to facilitate the effective monitoring of the real-time status of UPS and timely feedback
the status to monitor when abnormal situation occurs (such as UJPS failure, mains interruption,
UPS bypass and ect.). It is installed in the intelligent slot of the UPS.
The relay card includes 6 output ports and one input port. Please refer to the following table for
detail.
UDD-SD-125/ Release Date: 20.01.2015/Rev No: 0/Rev.
This UPS is fitted with a voltage free contact closure
signal for use with an external automatic disconnect
device (by others) to protect against back-feeding
voltage into the incoming bypass supply
External fire detector has been activated.
External smoke detector has been activated.
Battery has been damaged, this warning shall occur.
Battery over-temperature, this warning shall occur.
Model setting of the UPS is incorrect.
Date
:
51
Advertisement
Table of Contents
