FLIR PT-602CZ Installation Manual page 33

2 Basic Operation and Configuration
Sensor > Communications > Networking
It is also possible to limit access to the camera from a client program by IP address. To do so set the
Allow anonymous clients parameter to No, and then add in the allowed addresses in the Remote
Clients list and click Save.
Note, once one or more addresses has been added to this list, only these computers will be able to
access the camera as a client. Be sure to remember which addresses are allowed.
Sensor > Communications > Serial Remote
427-0038-00-12 Version 110
Toggle Server (Stop/Start)
March 2018
Allowed
addresses
Set
Bosch
settings
Pelco-D
settings
Select
protocol
Save
33