Camera Connections; Removing The Back Cover - FLIR PT-602CZ Installation Manual

1 PT-602CZ Camera Installation
Step 5
1.5
1.5.1
Use a 2.5 mm hex key to loosen the
captive screws and remove the cover,
exposing the connections at the back of
the camera. There is a grounding wire
connected between the case and the
back cover
427-0038-00-12 Version 110
Ensure the camera is properly grounded. FLIR requires using a 14 AWG to 16 AWG
grounding strap anchored to the ground lug on the back plate of the camera housing and
then terminated to the nearest earth-grounding point.
Figure 1-3: PT-602CZ Galvanic Isolation Kit (4204960)

Camera Connections

Removing the Back Cover

M8 or 5/16" fasteners (not supplied)
4 places, minimum length 1 in.
(dependent on mounting structure)
isolation plate
example mounting structure
(FLIR PN 500-0461-00)
March 2018
If using nylon flat washers,
apply a generous coat of Tef-Gel
filling all gaps and voids.
(4 places)
M8 split lock washer (4 places)
M8 flat washer (4 places)
M8 nylon shoulder washer or
nylon flat washer (4 places)
If using nylon flat washers,
apply a generous coat of Tef-Gel
filling all gaps and voids.
(4 places)
10