FLIR PT-602CZ Installation Manual page 30

2 Basic Operation and Configuration
Server > Services > Date and Time
The date, time, and time zone can be obtained from an NTP server, or can be entered manually. If the
NTP mode is selected, the NTP server information can be entered. The NTP server address can be
entered as a static address or can be obtained via DHCP.
Toggle Server (Stop/Start)
Note
The server must be stopped before date and time settings can be changed.
Set the date and time parameters, then select the Save button at the bottom. After saving the settings,
Server > Server Status, pg. 31.
reboot the system. Refer to
If the Custom mode is selected, a pop-up window allows the
information to be entered manually.
Set the date and time parameters, then select the Save
button at the bottom.
427-0038-00-12 Version 110 March 2018 30