Installation Of Camera And Galvanic Isolation Kit - FLIR PT-602CZ Installation Manual

1 PT-602CZ Camera Installation
Once the mounting location has been selected, verify both sides of the mounting surface are
accessible.
Use a thread locking compound such as Loctite 242 or equivalent with all metal to metal threaded
connections.
Once the holes are drilled in the mounting surface, install four (4) stainless steel 5/16 or M8 bolts with
stainless steel washers and lock washers through the base of the camera.
1.4.3
Important Safeguards and Warnings
• Installation and servicing should be done by qualified installation and service personnel only.
• Installation should be done according to all local and national electrical and mechanical codes,
using only approved materials.
• Use stainless steel hardware to fasten mounts to outdoor surfaces.
• To prevent damage from water leakage when installing outdoors, apply sealant around the bolt
holes between the mount and the mounting surface.
Caution!
Following this procedure is critical to maintaining the warranty on your PT-602CZ product.
Failure to follow these instructions can potentially void the camera warranty.
Step 1
Step 2
Step 3
Step 4
427-0038-00-12 Version 110

Installation of Camera and Galvanic Isolation Kit

Description
Isolation plate
a
M8 nylon flat washer
M8 nylon shoulder washer
M8 split washer, S.S.
M8 washer, S.S.
a
Tef-Gel TG .25, 3 cc syringe
a. Use the alternate nylon flat washers and Tef-Gel lubricant on fasteners for PT-602CZ camera bases with
mounting holes that are too small to accept the shoulder washers. A syringe of Tef-Gel may be supplied in
the mounting kit when the nylon flat washer is expected to be required.
Determine the correct positioning of the isolation plate (See
Place the isolation plate and the camera on the mounting structure aligning the bolt holes or
studs.
Install nylon shoulder washers (4x) or alternate nylon flat washers (4x) onto camera base.
If using nylon flat washers, apply a generous coat of Tef-Gel filling all gaps and voids.
Secure the camera using 5/16" or M8 fasteners (4x) with stainless steel flat washers and
split washers on top of the nylon washers.
Table 1-1: Kit Contents
Qty
1
6
6
Two extra pieces of each attaching part are
supplied in the kit.
6
6
optional
March 2018
Figure 1-3 on page 10).
9