Serial Communications Settings - Hardware Dip Switches - FLIR PT-602CZ Installation Manual

1 PT-602CZ Camera Installation
Note
The terminal blocks for serial connections will accept a maximum 20 AWG wire size.
Note
The serial communications parameters for the PT-602CZ camera are set or modified either via
hardware DIP switch settings or via software, through a web browser interface. A single DIP switch
(SW103-9), Software Override determines whether the configuration comes from the hardware DIP
switches or the software settings.
Note
The DIP switches are only used to control serial communications parameters. Other settings, related
to IP camera functions and so on, must be modified via software (using a web browser).
1.5.6
The camera has two blocks of DIP switches that are used to configure the serial communications
settings. One block of switches has 8 switches and is used to set the serial address (or ID) of the
camera. The other block of switches has 10 switches and is used to set baud rate, hardware protocol
(RS-232 or RS-422), serial protocol (Pelco D or Bosch), and Software Override.
The figure below shows the locations of dip switches SW102 and SW103.
When the Software Override DIP switch is set to the Off position (as it is by default), all of the other DIP
switches will be ignored, and configuration changes must be made through software. If the switch is
set to the On position, all configuration settings related to serial communications are made with the
DIP switches, and changes that are made via software (with a web browser) will be ignored.
Serial Address: Use the block of switches on the left (SW102) to set the serial address of the
camera. The available range of values is from decimal 1 to 255. The dip switches are interpreted as a
binary number, with switch 1 representing the least significant bit (the switches are in the reverse order
of the bits). For convenience, a table of serial addresses and their binary equivalents is included at the
end of the manual. Refer to
427-0038-00-12 Version 110

Serial Communications Settings - Hardware DIP Switches

SW102
Figure 1-5: PT-602CZ Camera Configuration
Serial Address: Decimal To Binary Conversion, pg. 47
March 2018
SW103 Switch
Position
Off
On
13