Log Into The Camera Web Page - FLIR PT-602CZ Installation Manual

2 Basic Operation and Configuration
2.2.2
Log into the camera using one of three User Names: user, expert, and admin (the corresponding
passwords by default are user, expert, and admin respectively). The user login can be used to do the
initial bench test of the camera. The expert login may be used to make configuration changes such as
setting the IP address and other server settings. The admin login has access to all configuration,
setup, and maintenance settings. The login passwords should be changed (admin login required) to
prevent unauthorized access. Two web sessions can be active at once. An inactive session will be
logged out after 20 minutes.
The login passwords should be changed (admin login required) to prevent unauthorized access. For
information on how to change the passwords, refer to
Note
A VMS Remote to the camera, ONVIF or Nexus CGI, uses the same password as the web interface.
Refer to
Open a web browser and enter the camera's IP address. The login screen with a picture of the camera
will appear. Enter user for the User Name and user for the Password, and click Log in.
427-0038-00-12 Version 110

Log into the Camera Web Page

Sensor > Communications > VMS Remote, pg.
Figure 2-1: Camera Web Page Login Screen
Server > Security Options, pg.
34.
March 2018
32.
20