Diagnosis; Menu Options - Xtool EZ400PRO Manual

EZ400PRO Diagnosis System
3.2.2. When pull and plug test wire harness, users should pinch the front-end of the wire
harness to pull and plug, not pull the middle section of the wire harness. Users should check
the corresponding direction of the port and plug in horizontally when they plug the wire
harness, instead of inserting in an oblique way, which may damage the terminal.
3.2.3. When taking some special functions tests, users are required to operate the device
according to operating instructions. For vehicle, it has to strictly meet the requirements, for
example, the conditions that some vehicle models need to be reached are as follows: engine
temperature 80℃/105℃, turn off the loads (such as headlights, air-conditioner, etc.), put
accelerator pedal in released position, etc.
3.2.4. The ECU for Chinese domestic vehicle models are relatively disorderly, so when users
meet conditions, such as the car can not be tested or the test data is wrong, they should
consider whether the selected menu corresponds to the tested electronic control system, or
they can find the car ECU and select the right menu according to the model number on the
ECU label.
3.2.5. If users can not find the tested vehicle model or electronic control system in EZ400PRO
test menu, they may need to update the software or consult Xtool technical service department
3.2.6. Banned to have connection test by using harness not from Xtool to avoid unnecessary
losses.
3.2.7. Banned to power off directly in the communication between EZ400PRO and vehicle.
Users should cancel the task and return to the main interface, then power off.
3.2.8. The device should be put and lifted slightly to avoid collision when using EZ400PRO.
When click the screen, touch it gently to guarantee the service life of the touch screen.
3.2.9. During long period of non-use, please disconnect the power and turn it off.

4.Diagnosis

4.1. Menu Options

4.1.1. After EZ400PRO tablet connected to vehicle via main cable, diagnosis can be
performed now. The diagnostic interface comes up as below.
4.1.2. Users can choose menu based on their actual needs: selection for Europe means
8