When Messages Appear; When Messages Appear And The Machine Cannot Be Operated - Ricoh Pro C9200 Operator's Manual

7. Troubleshooting

When Messages Appear

This section describes the machine's main messages. If other messages appear, follow their instructions.

When Messages Appear and the Machine Cannot Be Operated

Message
"Please Wait."
"Please Wait."
"Please wait."
238
Cause
The cable which connects
the machine and the
external color controller is
disconnected.
This message appears when
you press the [Energy Saver]
key or the [Check Status]
key.
This message appears when
the machine is warming up.
Solution
Securely connect the machine and
external color controller by using the
cable.
Wait for a while. If the machine is not
ready in 5 minutes, turn off the power
and make sure the main power
indicator turns off. Wait at least 20
seconds, and then turn on the power
again. If the machine is still not ready
in 5 minutes, contact your service
representative.
• Wait until the message
disappears. Do not turn off the
power while the message is
showing.
• If the machine is not ready in 10
minutes, turn off the power and
make sure the main power
indicator turns off. Wait at least
20 seconds, and then turn on the
power again. If the machine is still
not ready in 10 minutes, contact
your service representative.