Ricoh Pro C9200 Operator's Manual page 280

8. Maintenance
• This machine uses two power cords. To stop the power supply of the machine completely,
remove both power plugs. Unless both power plugs are removed, fire or electric shock may
result.
• The capacity of power in this machine is 60 A and 9,000 W with both cords combined.
Connect each cord to separate power sources with independent breakers. If you connect to an
electrical outlet that is connected to the same breaker, the breaker may cut off power.
• Be sure to push the plug of the power cord fully into the wall outlet. Partially inserted plugs
create an unstable connection that can result in unsafe buildup of heat.
• If this machine is not going to be used for several days or longer at a time, disconnect its power
cord from the wall outlet.
• When disconnecting the power cord from the wall outlet, always pull the plug, not the cord.
Pulling the cord can damage the power cord. Use of damaged power cords could result in fire
or electric shock.
• Be sure to disconnect the plug from the wall outlet and clean the prongs and the area around
the prongs at least once a year. Allowing dust to build up on the plug constitutes a fire hazard.
• When performing maintenance on the machine, always disconnect the power cord from the
wall outlet.
• Power Source
•
220–240 V, 30 A, 50/60 Hz
•
208–240 V, 30 A, 50/60 Hz
Please be sure to connect the power cord to a power source as above.
• Voltage tolerance
Voltage must not fluctuate by more than 10%.
• This machine uses two power cords. Connect each power plug to separate power sources with
independent breakers.
278
(mainly Europe and Asia)
(mainly North America)