When Other Messages Appear - Ricoh MP W6700SP User Manual

When Other Messages Appear

Message
"Cannot connect with the
wireless card. Turn the main
power switch off, then check
the card."
"Clean the scanning glass."
"Following output tray is full.
Remove paper."
"Internal cooling fan is
active."
"Self checking..."
Cause
• The wireless LAN
board was not inserted
when the machine was
turned on.
• The wireless LAN
board was pulled out
after the machine was
turned on.
• The settings are not
updated although the
unit is detected.
The scanning glass is dirty.
The output tray is full.
The internal cooling fan may
start running to cool the
interior of the machine.
The machine is performing
image adjustment
operations.
When Other Messages Appear
Solution
Turn off the power, and then check the
wireless LAN board is inserted
correctly. After this, turn on the power
again. If the message appears again,
contact your service representative.
Clean the scanning glass. See
"Maintaining Your Machine",
Maintenance and Specifications.
Remove paper from the output tray to
resume printing.
The fan will emit noise, but this is
normal and the machine will be
operable while the fan is running.
The amount of paper that can be
printed and the total operation time
until the fan starts running depends on
the temperature of the location at
which the machine is installed.
The machine may perform periodic
maintenance during operations. The
frequency and duration of
maintenance depends on the humidity,
temperature, and printing factors such
as number of prints, paper size, and
paper type. Wait for the machine to
resume operation.
163