Advertisement
Firmware update
BETAFLIGHT firmware allready flash before leave the factory,user just need
connect PC to adjust the parameter.
1.Open betaflight configuration
OMNIBUS
3.1.7-OMNIBUS -10-04-2017 18:36(stable)
2.Click
updating finish into setting menu
3.Calibration"Calibrate Accelerometer"
4.Selected UART3,then open"Serial RX"switch and saved
5.Configuration，select ESC protocol"DSHOT600"，Set up the receiver protocol，then openLED,OSD and
DYNAMIC_FILTER
,then click
,then click
-8-
,select FW version
to download FW to FC, click
after FW
Connect
Advertisement
Need help?
Do you have a question about the FLYEGG100 V2 and is the answer not in the manual?