Page 1
AC900(S-FHSS+D16) ET100 V2 PNP ET115 3S PNP ET125 V2 PNP ET V2/3S Series Instruction manual User manual and video please visit:WWW.LDARC.COM Note: 2S configuration using 3S battery will cause damage to electronic equipment Name ET100 V2 ET115 3S ET125 V2...
Page 5
Pin definition AUDIO BATTERY+ CURRENT BATTERY+ SIGNAL BATTERY+ VIDEO AUDIO PWM4 PWM3 PWM2 PWM1 BATTERY+ BETAFLIGHT 5V(BUZZER+) LED STRIP BATTERY+ PPM+RX2-INV BUZZER- VIDEO Only KKT-F411(20x20)-90214 version TX2-INV BATTERY+ RX2-INV VIDEO Supply voltage is 5V Supply voltage is 3.3V S.BUS and PPM receiver connection DSM2 and DSMX receiver connection PPM or invert RX2 signal input NOT invert RX2 signal input...
Page 6
Motor M4(CW) M2(CCW) M3(CCW) M1(CW) Note:pay attention to the direction of rotation of the motor when installing the prop Receiver Bind AC900(S-FHSS+D16) bind,transmitter(FRSKY X9D/Futaba T18SZ) Bind:Check receiver mode before bind,the first blink after power on indicate the setting, is S-FHSS, is D16 FUTABA S-FHSS BIND:Turn on the TX then power on AC900 while pressing the key, green LED fast blink meaning already in bind mode, user can release the key.
Page 8
RX2A PRO Bind(S.BUS),transmitter(FLYSKY FS-i6) BIND:Power on the receiver while pressing the key,green LED fast blink meaning already in bind mode, user can release the key,then set your TX into bind mode.Green LED turn off and red LED solid mean bind finished, exit TX from bind mode,receiver’...
Page 9
5.Configuration,select ESC protocol“DSHOT600”,Set up the receiver protocol,then open LED,OSD and DYNAMIC_FILTER 6.PID setting...
Page 10
7.Default setting of receiver is 5th channel ARM(AUX1),6th channel mode switching(AUX2) FLIP OVER AFTER CRASH please upgrade the firmware to 3.2.1 version first,then set by BETAFLIGHT 8.Setting 7th channel mode switching(AUX2). 9.Input“set small_angle = 180 ”,then set...