LDARC FLYEGG100 V2 Instruction Manual page 6

Receiver Bind
AC900(S-FHSS+D16) bind,transmitter(FRSKY X9D/Futaba T18SZ)
Bind:Check receiver mode before bind,the first blink after power on indicate the setting,
FUTABA S-FHSS BIND:Turn on the TX then power on AC900 while pressing the key, green LED fast blink meaning already in bind
mode, user can release the key. Bind procedure is completed and the receiver is working normally when green LED is solid
FRSKY D16(NO Telemetry) BIND:Power on AC900 while pressing the key, green LED fast blink meaning already in bind mode,
user can release the key, then set your TX into D16 bind mode. red LED solid meaning bind finished, exit TX from bind mode,
receiver's green LED solid meaning working normally
RX2A PRO Bind(S.BUS),transmitter(FLYSKY FS-i6)
BIND:Power on the receiver while pressing the key,green LED fast blink meaning already in bind mode,user can release the key,
then set your TX into bind mode.Green LED turn off and red LED solid mean bind finished,exit TX from bind mode,receiver' s
green LED solid mean working normally.
FAILSAFE:Support 2 failsafe mode,press the key and hold 3s while receiver working normally can switch failsafe mode.Please
make sure failsafe is working correctly before use the receiver!
Failsafe mode 1: After 1s when lost transmitter signal,S.BUS keep output,throttle will 988us,all other channels will 1500us.
Failsaft mode 2: After 1s when lost transmitter signal,S.BUS not output,user should setting related parameters to ensure
flight controller handle failsafe.
STATUS LED：LED of RX2A-PRO blink twice then solid when power on,the meaning as follow
First blink(air system)
AFHDS2A air system
Second blink(failsafe mode)
Failsafe mode 1
Failsafe mode 2
-5-
is S-FHSS, is D16
Then solid(signal status)
No signal
Signal received