Page 1
The company will not be responsible for any changes in the product, nor can we actively inform consumers of any updates or changes. If there is any change in the material, specification or contents of package, please refer to LDARC.COM This product is suitable for people aged 14 and above.
Allow the drone to initialize and arm properly Fly the model Land the model Unplug the flight battery Always turn the transmitter off last Configuration:FB400 PNP,FB4000 RTF,FB400NZ RTF FB400 PNP/RTF Parameter Configuration FB400NZ RTF 225mm Wheelbase 225mm 400mm Outer diameter 400mm 11.1-15.2V...
Page 3
FB400NZ RTF: FB400NZ (electronic+frame) *1, Outer frame*4 bags, prop*2 bags, transmitter*1 Remarks: Some outer frame and propeller have been installed before shipped FB400 PNP Receiver(AC2000):Yellow is the S.BUS signal wire, red is 5V, and black is GND; And set it correctly in INAV。...
Page 4
FB400 PNP/ RTF Check the neutral position of the remote control Connect the INAV software, enter the receiver option, check the neutral position 1500 of the remote lever and the switch channel, please refer to the instructions of the remote control for adjustment.
Page 5
b) Executing CSC; c) Throttle stick under 10%, and after landing for more than 3 seconds. d) If the angle of multi-rotor is over 70°, and throttle stick under 10%. FB400NZ RTF Sticks Calibration Set endpoints of all channels to default values (100%) and set all trims and sub-trims of ...
Page 6
Notices: All slides should become when all the sticks are in the middle positions. If slides cannot go back to center points (become ), just click FINISH, then slides will be at center automatically. If still not, please reboot MC, and do not apply TX command during the reboot. CSC may not start motors If trims and sub-trims of sticks are not 0! ...
Page 7
Outer frame mounting:Put on the heat shrink tube before connecting, then insert the plug, and finally shrink the heat shrink tube Mounting propeller Other parts of the installation M3*10, M3 nut M3*6...
Page 9
PNP/RTF version factory inspection report Flight Test Check List The transmitter functions normally Test flight in good condition Camera definition is good VTX quality is good Packing report Air frame Transmitter Air frame matches the transmitter ID ...