Related Manuals for LDARC ET MAX
Summary of Contents for LDARC ET MAX
- Page 1 Instruction manual User manual and video please visit: WWW.LDARC.COM 181205...
-
Page 2: Frequency Table
ET MAX Configuration Wheelbase：185mm KK Tower： F4+OSD 4in1 20A BLheliS OFF/25/100/200mW 48CH Camera：(1200TVL 1/3’COMS NTSC) Motor：MB2204-2250KV Prop：4*4.5*3 Weight：283g(not include battery and receiver) Pack List 4*4.5*3×１0 Pairs Magic tape*1 PNP×１ ET MAX 产品说明书请登陆 : WWW.LDARC.COM 产品分类 多旋翼 ET系列 ET MAX 说明书... - Page 3 KK Tower Frequency button Power 2~4S Antenna plug(I-PEX) Camera 5V+ GND VIDEO AUDIO BOOT LED+Buzzer VIDEO Receiver 5V(BUZZER+) LED(S) BUZZER- 3V3 RC IN Connect these 3 pads to VTX when 3V3 RC IN DSMX use 2L tower(FC+ESC) RC IN S.BUS/PPM Connect FC 5V GND B+ Frequency button...
- Page 4 Receiver Bind AC900(S-FHSS+D16 non-EU) bind,transmitter(FRSKY X9D/Futaba T18SZ) Bind:Check receiver mode before bind,the first blink after power on indicate the setting, is S-FHSS, is D16(non-EU) FUTABA S-FHSS BIND:Turn on the TX then power on AC900 while pressing the key, green LED fast blink meaning already in bind mode, user can release the key.
-
Page 6: Factory Setting
PART.KK TOWER SCREW(3 LAYER) PROP.4*4.5*3 4*4.5*3 Prop(clear black) PART.4 INCH PROPELLER BUMPER 4 Inch propeller bumper Carbon plate(ET MAX part) PART.BOTTOM PLATE.ET MAX LED+Buzzer(ET V2/3S part) PART.LED+BUZZER(ET V2/3S PART) Factory setting The factory has already load the firmware, default angle mode, please set directly 1.Open Betaflight... - Page 7 3.Prot,open UART6 switchable and saved 4.Select ESC protocol“DSHOT600”，set up the receiver protocol, open LED_STRIP,OSD,DYNAMIC_,FILTER Please refer to the receiver section to set the receiver protocol...
- Page 8 5.PID setting...
- Page 9 6.Setting the receiver lever neutral position 7.Default angle mode,setting of receiver is 5th channel ARM(AUX1) 8.LED setting,then saved...
- Page 10 When the drone is not flying properly, try to load FC firmware,then restore factory settings 1.Open ，then click ，select firmware OMNIBUSF4SD 3.2.1- OMNIBUSF4SD -18-10-2017 03:31(stable) 2.Click ，then click to download FW to FC， click after FW updating finish into setting menu Connect Flip Over After Crash Setting Setting ESC protocol is“DSHOT600”...
-
Page 11: After-Sale Service
After Sale Service 1.Provide free reparation service when find the product defect after purchase. 2.Provide pay-needed reparation service when product damage because improper operation. 3.China customers please contact with the after-sales service,overseas client please contact the dealer. PNP/RTF Test report ID : Flight test Package check...