Audio Board - HP Spectre x360 Maintenance And Service Manual

Reverse this procedure to install the heat sink on the system board.

Audio board

Description
Audio board
Audio board cable
IMPORTANT:
and replacement.
Before removing the heat sink, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off/or in Hibernation, turn the computer
on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the fans (see
7. Remove the system board (see
Remove the audio board:
1. Remove the screw securing the audio board (1).
2. Remove the audio board (2).
50 Chapter 5 Removal and replacement procedures for authorized service provider parts
Make special note of each screw and screw lock size and location during removal
Bottom cover on page
Battery on page
Fans on page
System board on page
34).
35).
44).
46).
Spare part numbers
L37655-001
L37656-001