Table of Contents
Advertisement
A
Caring for Connectors
Hold the torque wrench lightly by the knurled end of the handle only. Apply force
at the end of the torque wrench only, perpendicular to the wrench and always in a
plane parallel to the outer conductor mating planes. This will result in torque
being applied to the connection through the wrench until the break point of the
wrench is reached.
Avoid pivoting the wrench handle on the thumb or other fingers. This results in an
unknown amount of torque being applied to the connection when the break point
of the wrench is reached. Avoid twisting the head of the wrench relative to the
outer conductor mating plane. This results in applying more than the
recommended torque.
Table A-2
Type
Precision 7 mm
Precision 3.5 mm
SMA
Type-N
To reiterate the main do's and do not's detailed previously:
– Avoid holding the wrench tightly, in such a way that the handle is not pivoted
– Hold the wrench at the same point near the end of the handle every time, and
76
Recommended torque settings
Description
12 lb-in (136 N-cm)
8 lb-in (90 N-cm)
5 lb-in (56 N-cm)
Use the SMA wrench to connect male SMA connectors to female precision
3.5 mm connectors.
Connections of male precision 3.5 mm connectors to female SMA connectors
can be made with the precision 3.5 mm torque wrench (8 lb-in).
Type-N connectors may be connected finger tight. If a torque wrench is used,
12 lb-in (136 N-cm) is recommended.
but simply pushed downward the same amount throughout its length. If this is
done, an unlimited amount of torque can be applied.
always in the same orientation. Whenever possible, begin tightening the
connection with the wrench held horizontally.
Keysight N4000/1/2A Operating and Service Manual
Advertisement
Table of Contents
