Rail Mounted Version (X100Lr); Desk Mounted Versions (X100Ld / X100Lds / X100Lfdm) - DARAY X100 Operating & Installation Manual

4.2 Rail mounted version (X100LR)


Remove the light from its packaging.

If you have also purchased our XRAIL accessory, hold the rail against the
selected location on the wall, bearing in mind the final position and range of
travel of the light-head required to project its light patch where it will be
needed.

Ensuring the rail is horizontal; mark the positions for the 2 screw holes.

Fix the rail to the wall, using appropriate plugs as necessary and the 2 screws
provided.
NOTE: Slide the screw-head cap retainers the correct way up onto the screws
before fitting the screws!

Fit the screw-head caps.

Ensure the rail end caps are properly fitted.

Slacken sufficiently the light clamp to allow the clamp to pass over the rail
and fit the light to the rail.

The light can be moved along the rail by slackening the clamp slightly and not
sufficiently to allow the light to become detached from the rail.

4.3 Desk mounted versions (X100LD / X100LDS / X100LFDM)

X100LD (includes PIVOTD2 desk clamp)

Remove the light from its packaging.

Slacken the desk clamp so that its jaws just clear the desk edge.

Tighten the clamp sufficiently to provide a rigid mounting for the light.

Fit the spigot on the end of the light arm into the top of the clamp, make
sure it is fully secured in place.

Apply the power cable, and power the light on. See page 8.
X100LDS (includes PIVOTS weighted base)

Remove the light from its packaging.

Fit the spigot on the end of the light arm into the top of the weighed base,
make sure it is fully secured in place.

Apply the power cable, and power the light on. See page 8.
X100LFDM (includes PIVOTFDM fixed desk mount)

Remove the light from its packaging.

Mark the position on the desk for mounting. Use screws the fix the bracket
securely.
Page 12 of 22