Table of Contents
Advertisement
3. INSTALLATION
Wall Mounting
For flush mounting (chased-in cables), refer to the electrician's wiring supplement
supplied with Electrician's Kit DRK4064
CAUTION: This product must be earthed.
•
Remove the 4 cover screws with the hex
wrench provided
•
Release the earth bond from the back-
plate by removing the nut and
shake-proof washer
•
Using the back-plate as a template,
mark its position on the wall, bearing in
mind the final position of the light-head
•
Fix the bracket to the wall
•
Whilst supporting the weight of the
power supply module and
light, replace the earth
bond to the back-plate
with the shake-proof
washer and nut
•
Fit the power supply
module to the wall
bracket with the 4 cover
screws
•
Connect the IEC flex to
the socket on the side of
the power supply module
•
Plug the IEC flex into a
13A mains socket and
check for correct
operation
Rail mounting
•
Hold the rail against the selected location
on the wall, bearing in mind the final
position and range of travel of the light-
head required to project its light patch
where it will be needed.
•
Ensuring the rail is horizontal; mark the
positions for the 2 screw holes.
•
Fix the rail to the wall, using appropriate
plugs as necessary and the 2 screws
provided.
NOTE: Slide the screw-head cap retainers the
correct way up onto the screws before fitting
the screws
5
Advertisement
Table of Contents
