Replacing The Liquid End - BRAND Liquid Handling Station Operator's Manual

5 Replacing the Liquid End

1. Grasp the Liquid End and press the decoupling button. The Liquid End is automatically
released from the motor control unit. If the Liquid End is replaced while the Liquid
Handling Station is turned off, it must be pulled downwards with the decoupling button
pressed.
2. Insert the new Liquid End vertically into the motor control unit from below.
3. Push it upwards until it engages.
If different Liquid Ends are needed for the method to run, a message will appear on
the screen prompting you to replace them as required.
23