Configuring Is-Is Route Redistribution - H3C S5800 Series Configuration Manual
Layer 3 - ip routing
Hide thumbs
Also See for S5800 Series:
- Installation manual (101 pages) ,
- Quick start manual (33 pages) ,
- Troubleshooting manual (26 pages)
Table of Contents
Advertisement
# Display information about IS-IS neighbors and interfaces of Switch C.
[SwitchC] display isis peer
System Id: 0000.0000.0002
Interface: Vlan-interface100
State: Up
System Id: 0000.0000.0001
Interface: Vlan-interface100
State: Up
[SwitchC] display isis interface
Interface: Vlan-interface100
Id
IPV4.State
001
Up
# Display information about IS-IS neighbors and interfaces of Switch D.
[SwitchD] display isis peer
System Id: 0000.0000.0001
Interface: Vlan-interface100
State: Up
System Id: 0000.0000.0002
Interface: Vlan-interface100
State: Up
[SwitchD] display isis interface
Interface: Vlan-interface100
Id
IPV4.State
001
Up
Configuring IS-IS Route Redistribution
Network requirements
As shown in
Figure
IS-IS to interconnect. Switch A and Switch B are Level-1 routers, Switch D is a Level-2 router, and
Switch C is a Level-1-2 router.
It is required to redistribute RIP routes into IS-IS on Switch D.
Peer information for ISIS(1)
----------------------------
HoldTime: 25s
HoldTime: 7s
Interface information for ISIS(1)
---------------------------------
IPV6.State
Down
Peer information for ISIS(1)
----------------------------
HoldTime: 9s
HoldTime: 28s
Interface information for ISIS(1)
---------------------------------
IPV6.State
Down
5-18, Switch A, Switch B, Switch C and Switch D reside in the same AS. They use
Circuit Id: 0000.0000.0001.01
Type: L1
PRI: 64
Circuit Id: 0000.0000.0001.01
Type: L1
PRI: 100
MTU
Type
DIS
1497
L1/L2 No/No
Circuit Id: 0000.0000.0001.01
Type: L2
PRI: 100
Circuit Id: 0000.0000.0001.01
Type: L2
PRI: 64
MTU
Type
DIS
1497 L1/L2
No/No
5-49
Advertisement
Table of Contents
Troubleshooting
