Configuring The Interval For Sending The Same Update - H3C S5800 Series Configuration Manual

If two parties have the same timer assigned with different values, the smaller one is used by the two
parties.
Follow these steps to configure BGP keepalive interval and holdtime:
Enter system view
Enter BGP view
Configure the global keepalive interval
and holdtime
Configure the keepalive interval and
holdtime for a peer/peer group
The maximum keepalive interval should be one third of the holdtime and no less than 1 second.
The holdtime is no less than 3 seconds unless it is set to 0.
The intervals set with the peer timer command are preferred to those set with the timer
command.
If the router has established a neighbor relationship with a peer, you need to reset the BGP
connection to validate the new set timers.

Configuring the Interval for Sending the Same Update

Follow these steps to configure the interval for sending the same update to a peer/peer group:
Enter system view
Enter BGP view
Configure the interval for sending the same
update to a peer/peer group
To do...
To do...
Use the command...
system-view
bgp as-number
timer keepalive keepalive hold
holdtime
peer { group-name | ip-address }
timer keepalive keepalive hold
holdtime
Use the command...
system-view
bgp as-number
peer { group-name |
ip-address }
route-update-interval interval
6-35
Remarks
—
—
Optional
By default, the keepalive
interval is 60 seconds, and
holdtime is 180 seconds.
Remarks
—
—
Optional
The intervals for sending the
same update to an iBGP
peer and an eBGP peer
default to 15 seconds and
30 seconds respectively.