Displaying And Maintaining Static Routes; Prerequisites··································································································································4 - H3C S5800 Series Configuration Manual

Configuration prerequisites
Configuring static route FRR needs to reference a route policy. You can specify a backup next hop in a
route policy by using the apply fast-reroute backup-interface command. For details about the
command and routing policy configurations, see Route Policy Configuration in the Layer 3 - IP Routing
Configuration Guide.
Configuration procedure
Follow these steps to configure static route FRR:
To do...
Enter system view
Configure the source address of
echo packets
Configure static route FRR
Static route FRR takes effect only for static routes that have both the outbound interface and next
hop specified.
Do not use static route FRR and BFD for static routing at the same time.

Displaying and Maintaining Static Routes

To do...
Display the current configuration
information
Display the brief information of the
IP routing table
Display the detailed information of
the IP routing table
Display static route information
Delete all the static routes
Use the command...
system-view
bfd echo-source-ip ip-address
ip route-static [ vpn-instance
vpn-instance-name ] fast-reroute
route-policy route-policy-name
Use the command...
display current-configuration
display ip routing-table
display ip routing-table verbose
display ip routing-table protocol static [ inactive |
verbose ]
delete [ vpn-instance vpn-instance-name ]
static-routes all
2-6
Remarks
—
Required
Not configured by default.
Required
Not configured by default.
Remarks
Available in any
view
Available In
system view