H3C S5800 Series Configuration Manual page 45

To do...
Disable an or all interfaces from
sending routing updates (the
interfaces can still receive
updates)
Return to system view
Enter interface view
Enable the interface to receive RIP
messages
Enable the interface to send RIP
messages
Configuring a RIP version
You can configure a RIP version in RIP or interface view.
If neither global nor interface RIP version is configured, the interface sends RIPv1 broadcasts and
can receive RIPv1 broadcast and unicast packets, and RIPv2 broadcast, multicast, and unicast
packets.
If an interface has no RIP version configured, it uses the global RIP version; otherwise it uses the
RIP version configured on it.
With RIPv1 configured, an interface sends RIPv1 broadcasts, and can receive RIPv1 broadcasts
and RIPv1 unicasts.
With RIPv2 configured, a multicast interface sends RIPv2 multicasts and can receive RIPv2
unicasts, broadcasts and multicasts.
With RIPv2 configured, a broadcast interface sends RIPv2 broadcasts and can receive RIPv1
unicasts, and broadcasts, and RIPv2 broadcasts, multicasts and unicasts.
Follow these steps to configure a RIP version:
To do...
Enter system view
Enter RIP view
Use the command...
silent-interface { interface-type
interface-number | all }
quit
interface interface-type
interface-number
rip input
rip output
Use the command...
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
3-8
Remarks
Optional
All interfaces can send routing
updates by default.
—
—
Optional
Enabled by default
Optional
Enabled by default
Remarks
––
––