Configuring A Dr Priority For An Interface - H3C S5800 Series Configuration Manual

To do...
Specify the poll interval
Configure the dead interval
Configure the LSA retransmission
interval
Configure the LSA transmission
delay
Return to system view
Enter OSPFv3 view
Configure the SPF timers
The dead interval set on neighboring interfaces cannot be too short. Otherwise, a neighbor is
easily considered down.
The LSA retransmission interval cannot be too short; otherwise, unnecessary retransmissions
occur.

Configuring a DR Priority for an Interface

Follow these steps to configure a DR priority for an interface:
To do...
Enter system view
Enter interface view
Configure a DR priority
Use the command...
ospfv3 timer poll seconds
[ instance instance-id ]
ospfv3 timer dead seconds
[ instance instance-id ]
ospfv3 timer retransmit interval
[ instance instance-id ]
ospfv3 trans-delay seconds
[ instance instance-id ]
quit
ospfv3 [ process-id ]
spf timers delay-interval
hold-interval
Use the command...
system-view
interface interface-type interface-number
ospfv3 dr-priority priority [ instance
instance-id ]
9-13
Remarks
Optional
The poll interval defaults to 120
seconds.
Optional
Defaults to 40 seconds on P2P,
broadcast interfaces.
Optional
Defaults to 5 seconds.
Optional
Defaults to 1 second.
—
—
Optional
By default, delay-interval is 5
seconds, and hold-interval is 10
seconds.
Remarks
—
—
Optional
Defaults to 1