Mce Configuration Examples; Using Ospf To Redistribute Vpn Routes Between An Mce And - H3C S5800 Series Configuration Manual

For commands to display information about a routing table, see IP Routing Basics Configuration
Commands in the Layer 3 - IP Routing Command Reference.

MCE Configuration Examples

Using OSPF to Redistribute VPN Routes Between an MCE and PE
Network requirements
See Figure 14-6.
An MCE device connects to VPN1 (with the address range being 192.168.0.0/16) through
VLAN-interface 10 (with the IP address being 10.214.10.3) and connects to VPN2 (with the
address range being 192.168.10.0/24) through VLAN-interface 20 (with the IP address being
10.214.20.3). VPN2 has RIP enabled.
The MCE device connects to the PE through VLAN-interface 30 and VLAN-interface 40, whose IP
addresses are 192.168.30.1/30 and 192.168.40.1/30, respectively.
It is required that the MCE device isolates routes of VPN1 from those of VPN2 and advertises all
the VPN routes to the PE device using OSPF.
Figure 14-6 Network diagram for MCE configuration (A)
VPN 1
192.168.0.0
VR1
Configuration procedure
For distinguish devices, assume the system name of the MCE device is "MCE", the names of the
egress router of VPN1 and VPN2 are "VR1" and "VR2", and the system name of the PE device is "PE".
GE1/0/3
MCE
Vlan-int30
GE1/0/10
10.214.30.1
Vlan-int40
Vlan-int10
10.214.40.1
10.214.10.3
GE1/0/20
Vlan-int20
10.214.20.3
VR2
RIP
192.168.10.0
VPN 2
PE
PE
GE1/0/18
14-24
VPN 2
Site 1
CE
PE
CE
Site 2
VPN 1